Inlet Manifold
-
- Posts: 42
- Joined: July 14th, 2006, 11:41 pm
- Location: Dublin Ireland
- Contact:
Inlet Manifold
Hi Guy
Would you have or could you advise me on where I would get a Inlet Manifold for a single Weber 40 DCNF carb to suit a Tipo 1400?. I have tryed many places inculding Chadil but to no avail.
Gary
Would you have or could you advise me on where I would get a Inlet Manifold for a single Weber 40 DCNF carb to suit a Tipo 1400?. I have tryed many places inculding Chadil but to no avail.
Gary
Thank you
-
- Site Admin
- Posts: 5039
- Joined: June 18th, 2006, 9:31 am
- Location: Bedford, UK
- Contact:
-
- Posts: 42
- Joined: July 14th, 2006, 11:41 pm
- Location: Dublin Ireland
- Contact:
GuyGuy Croft wrote:Truth is if you found one like the one I modified last you'd probably be shocked by the casting quality anyway! I was..
I would not try to find one. I would use the std one, cut off the old carb flange and weld a new one for the DCNF, get it fettled by yours truly.
OK?
GC
I could probely get a std one all right but where would i get the DCNF flange? Could you do the job for me, keeping in mind the regs i have to follow?
Gary
Thank you
-
- Site Admin
- Posts: 5039
- Joined: June 18th, 2006, 9:31 am
- Location: Bedford, UK
- Contact:
-
- Posts: 52
- Joined: July 21st, 2006, 10:47 am
- Location: Stroud, Gloucestershire
- Contact:
I'm sure Bogg Brothers could do the mod for you. I have heard lots of good things about their work.
http://www.boggbros.co.uk/contact.html
thank you,
Ben
http://www.boggbros.co.uk/contact.html
thank you,
Ben
-
- Posts: 42
- Joined: July 14th, 2006, 11:41 pm
- Location: Dublin Ireland
- Contact:
Benbenlilly wrote:I'm sure Bogg Brothers could do the mod for you. I have heard lots of good things about their work.
http://www.boggbros.co.uk/contact.html
thank you,
Ben
Thank you will try them.
Gary
Thank you
-
- Posts: 42
- Joined: July 14th, 2006, 11:41 pm
- Location: Dublin Ireland
- Contact:
http://www.ruppmann.com/
But the site is offline. Write Claus an email!
claus@ruppmann.com
Give him regards from me (Martin Ackermann) :)
/edit: He has another site online: http://www.crengineering.de
But the site is offline. Write Claus an email!
claus@ruppmann.com
Give him regards from me (Martin Ackermann) :)
/edit: He has another site online: http://www.crengineering.de
-
- Posts: 42
- Joined: July 14th, 2006, 11:41 pm
- Location: Dublin Ireland
- Contact:
Thanks MartinAcki wrote:http://www.ruppmann.com/
But the site is offline. Write Claus an email!
claus@ruppmann.com
Give him regards from me (Martin Ackermann) :)
/edit: He has another site online: http://www.crengineering.de
Thank you
Who is online
Users browsing this forum: No registered users and 6 guests