Race Engine Forum UK

Posted: **March 8th, 2007, 11:43 am**

Hi Guy

Would you have or could you advise me on where I would get a Inlet Manifold for a single Weber 40 DCNF carb to suit a Tipo 1400?. I have tryed many places inculding Chadil but to no avail.

Gary

Posted: **March 8th, 2007, 12:29 pm**

Truth is if you found one like the one I modified last you'd probably be shocked by the casting quality anyway! I was..

I would not try to find one. I would use the std one, cut off the old carb flange and weld a new one for the DCNF, get it fettled by yours truly.

OK?

GC

Posted: **March 8th, 2007, 12:50 pm**

Guy Croft wrote:Truth is if you found one like the one I modified last you'd probably be shocked by the casting quality anyway! I was..

I would not try to find one. I would use the std one, cut off the old carb flange and weld a new one for the DCNF, get it fettled by yours truly.

OK?

GC

Guy

I could probely get a std one all right but where would i get the DCNF flange? Could you do the job for me, keeping in mind the regs i have to follow?

Gary

Posted: **March 8th, 2007, 2:44 pm**

No, I have to avoid specials due to time constraints these days but any machine shop could make that from alloy patterned off the carb flange.
Maybe there is a site member who has that capability.

GC

Posted: **March 12th, 2007, 8:59 pm**

I'm sure Bogg Brothers could do the mod for you. I have heard lots of good things about their work.
http://www.boggbros.co.uk/contact.html

thank you,
Ben

Posted: **March 13th, 2007, 12:48 am**

benlilly wrote:I'm sure Bogg Brothers could do the mod for you. I have heard lots of good things about their work.
http://www.boggbros.co.uk/contact.html

thank you,
Ben

Ben

Thank you will try them.

Gary

Posted: **March 13th, 2007, 12:40 pm**

In igermany you can get manifolds in the "alquanti" style, new 200 Euro.

Posted: **March 13th, 2007, 10:13 pm**

Acki wrote:In igermany you can get manifolds in the "alquanti" style, new 200 Euro.

Hi Acki

Do you have a web address please?

Gary

Posted: **March 18th, 2007, 7:06 pm**

http://www.ruppmann.com/

But the site is offline. Write Claus an email!
claus@ruppmann.com

Give him regards from me (Martin Ackermann) :)

/edit: He has another site online: http://www.crengineering.de

Posted: **March 19th, 2007, 12:55 pm**

Acki wrote:http://www.ruppmann.com/

But the site is offline. Write Claus an email!
claus@ruppmann.com

Give him regards from me (Martin Ackermann) :)

/edit: He has another site online: http://www.crengineering.de

Thanks Martin

Posted: **March 19th, 2007, 3:37 pm**

Here a picture of the manifold: