8V TC valve seat cut angles
Posted: July 21st, 2011, 9:19 pm
Hi,
I am about to buy valve seat tool from Mira, but I would like to hear what formtool I should pick?
As I read your writings, you recommented 30/45/70 angles with 2mm seat width.
Mira has formtool 4187 which fulfills this but it can grind only 3,5mm lenght of 70 degrees angle. I'm not sure if it is enough?
Other that I found interesting, was Mira 4121, but it is not as recommented, 15/45/75, also with 2mm seat width, but width of those other angles it can do more.
Have you ever tested with those angles?
Br, Sami Jokela, Finland
BTW... 30/45/70, if I remember right, is the same that my Kawasaki GPz 1100 (ZX1100 A1) -83 uses.
I am about to buy valve seat tool from Mira, but I would like to hear what formtool I should pick?
As I read your writings, you recommented 30/45/70 angles with 2mm seat width.
Mira has formtool 4187 which fulfills this but it can grind only 3,5mm lenght of 70 degrees angle. I'm not sure if it is enough?
Other that I found interesting, was Mira 4121, but it is not as recommented, 15/45/75, also with 2mm seat width, but width of those other angles it can do more.
Have you ever tested with those angles?
Br, Sami Jokela, Finland
BTW... 30/45/70, if I remember right, is the same that my Kawasaki GPz 1100 (ZX1100 A1) -83 uses.