Hello,
Does any one have any information on road spec Chevette HSR valve springs, i.e. length, diameter and strength or is there an alternative that can be fitted.
Any help would be much appreciated as I'm attempting to have it ready for the rally car show at Chatsworth Hall in two weeks time
thank you
Dave
Chevette HSR valve springs
-
- Site Admin
- Posts: 5039
- Joined: June 18th, 2006, 9:31 am
- Location: Bedford, UK
- Contact:
Re: Chevette HSR valve springs
The valvetrain architecture is from Fiat twincam (under licence) - you can use GC triples in that, not have to worry about all those, er 'odd' setups with all that packing-up etc in the original.
GC
GC
- Attachments
-
- HSR GC spring.jpg (118.6 KiB) Viewed 4405 times
-
- misc 091.jpg (113.96 KiB) Viewed 4404 times
-
- Posts: 2
- Joined: May 21st, 2008, 2:35 pm
Re: Chevette HSR valve springs
Thanks Guy,
I thought it strange myself that the springs had all gone sloppy.
I've also had a reply from Terry Cobbold from the Droop Snoot Group and apparently the springs are the same as a single cam slant four engine.
thank you
Dave
I thought it strange myself that the springs had all gone sloppy.
I've also had a reply from Terry Cobbold from the Droop Snoot Group and apparently the springs are the same as a single cam slant four engine.
thank you
Dave
Who is online
Users browsing this forum: No registered users and 85 guests