VOLUMEX SCAVENGE PUMP WIRING
Posted: March 5th, 2008, 3:10 pm
Any fellow VX owners out there who can offer some advice please?
I've used the engine for a different application (no argueing with terminal tin-worm on the HPE) but retained the wiring loom. Along the way I've dispensed with fuel cut-off circuitry and may have mis-wired then.
Can anyone tell me if the pump is wired to run until the water temp. drops regardless of the ignition being on?
It seems to be wired on the same feed as the low oil pressure circuit but this doesn't seem correct as that is wired into an ignition activated circuit and my recollection is that the scavenge pump ran until the engine had lost most of its heat.
Any thoughts/comments gratefully appreciated before I tear the rest of my hair out.
thank you, Pewe.
I've used the engine for a different application (no argueing with terminal tin-worm on the HPE) but retained the wiring loom. Along the way I've dispensed with fuel cut-off circuitry and may have mis-wired then.
Can anyone tell me if the pump is wired to run until the water temp. drops regardless of the ignition being on?
It seems to be wired on the same feed as the low oil pressure circuit but this doesn't seem correct as that is wired into an ignition activated circuit and my recollection is that the scavenge pump ran until the engine had lost most of its heat.
Any thoughts/comments gratefully appreciated before I tear the rest of my hair out.
thank you, Pewe.