Anyone recognise this apparent Fiat crank/vr sensor
-
- Posts: 120
- Joined: December 9th, 2006, 4:57 pm
- Location: West Sussex,UK
- Contact:
Anyone recognise this apparent Fiat crank/vr sensor
The code I can make out is 022 06K.
I'm trying to get the pin layout for it, for a new ecu loom.
205 8v Track car
-
- Posts: 14
- Joined: June 24th, 2007, 12:15 pm
- Location: Camerley, UK (A)
- Contact:
Re: Anyone recognise this apparent Fiat crank/vr sensor
Magnei Marelli used by a lot of after market kits as well, Is it two wire or three wire? ( Third wire is for screening )
Darrian T90
-
- Posts: 120
- Joined: December 9th, 2006, 4:57 pm
- Location: West Sussex,UK
- Contact:
Re: Anyone recognise this apparent Fiat crank/vr sensor
ah, it's 3, i'm desperate for the correct pin layout. No pin reference numbers on it..aargh!
205 8v Track car
-
- Posts: 14
- Joined: June 24th, 2007, 12:15 pm
- Location: Camerley, UK (A)
- Contact:
Re: Anyone recognise this apparent Fiat crank/vr sensor
Just sent you a PM with link.
Pin 1 Return
Pin 2 Signal
Pin 3 Screen
Pin 1 Return
Pin 2 Signal
Pin 3 Screen
Darrian T90
-
- Posts: 120
- Joined: December 9th, 2006, 4:57 pm
- Location: West Sussex,UK
- Contact:
Re: Anyone recognise this apparent Fiat crank/vr sensor
you legend! Thanks ever so much! Even get to know the correct air gap which I believe was too wide previously
Sean
Sean
205 8v Track car
-
- Posts: 167
- Joined: June 25th, 2006, 10:56 pm
- Location: Poland, Czyzowice
- Contact:
Re: Anyone recognise this apparent Fiat crank/vr sensor
Such sensors can be bought easily for Fiat Cinquecento 700 for only about 10 pounds instead paying about 40-50 pounds for the same sensor for example for Intergrale. For Cinquecento it has only 2 wires but i never had any problems with it. The other difference may be the length of the cable(easy to fix).
The manufacturer is of course Magneti Marelli.
The manufacturer is of course Magneti Marelli.
Book#378
Who is online
Users browsing this forum: No registered users and 6 guests