Volumex supercharger overhaul - rebuild

Supercharging, turbocharging, charge cooling
Locked
Guy Croft
Site Admin
Posts: 5027
Joined: Sun Jun 18, 2006 10:31 am
Location: Lincoln, UK
Contact:

Volumex supercharger overhaul - rebuild

Post by Guy Croft » Sat Sep 02, 2006 5:36 pm

Showing steps in the rebuild of the low pressure supercharger used on the Lancia Volumex (Vx) unit. (The 'MM' prefix with the photos is the client's initials)
Attachments
MM Vx parts cleaned.jpg
Rotors, main casing and front, rear housings after decarbonising, dressing and beadblasting, ready for Xylan coating.
MM Vx parts cleaned.jpg (108.13 KiB) Viewed 8855 times
a 058.jpg
Internal parts pre-cleaned, gears, thrust washers, nuts etc
a 058.jpg (115.66 KiB) Viewed 8838 times
a 062.jpg
End covers and rotors coated with Xylan 1010 conductive polymer, this gives lower friction, quieter running and reduced clearances/better performance and less power loss.
a 062.jpg (111.85 KiB) Viewed 8815 times
a 064.jpg
New rear seals oiled lightly on outer diameter and ...
a 064.jpg (118.08 KiB) Viewed 8810 times
a 065.jpg
...gently pushed into place by hand using a special drift, they must sit square and sit right in their machined recess.
a 065.jpg (117.66 KiB) Viewed 8786 times
a 066.jpg
..whereas the front seals need a bit of help from the press after initial location by hand, again oiled on OD or they will never go in properly and likely end up torn (and leaky)
a 066.jpg (114.4 KiB) Viewed 8773 times
a 067.jpg
A press, and modest pressure with a decent mandrel needed to seat the front seals.
a 067.jpg (115.97 KiB) Viewed 8752 times
a 068.jpg
Remove the inner sleeve and oil the OD of the rear bearings and press in gently down to their seat, nice and square.
a 068.jpg (107.88 KiB) Viewed 8744 times
a 069.jpg
Rear bearings fitted, sleeves refitted, they should turn freely if the brgs are fitted properly. I like to have the number code facing out so you can see what's in there..
a 069.jpg (119.63 KiB) Viewed 8731 times
MM_01 Vx rebuild 001.jpg
Here is the front bearing, an SKF four-point contact type that I have had precision-reworked to 'C2' close axial tolerance. Position one inner sleeve in the front casing and ...
MM_01 Vx rebuild 001.jpg (117.74 KiB) Viewed 8711 times
MM_01 Vx rebuild 003.jpg
One front bearing pressed into place
MM_01 Vx rebuild 003.jpg (115.58 KiB) Viewed 8699 times
MM_01 Vx rebuild 007.jpg
With both bearings fitted and their outer sleeves installed the bearing retaining plate can be fitted, fit new spring washers and tighten the M6 nuts to 8lbf ft.
MM_01 Vx rebuild 007.jpg (116.82 KiB) Viewed 8693 times

Locked

Who is online

Users browsing this forum: No registered users and 1 guest