My Fiat Strada 130 TC - restore and tuning

Post pics of your car in here
Guy Croft
Site Admin
Posts: 5039
Joined: June 18th, 2006, 9:31 am
Location: Bedford, UK
Contact:

Re: My Fiat Strada 130 TC - restore and tuning

Post by Guy Croft »

Guilio,

I appreciate your courtesy but I don't mind at all if you name the supplier. CPS/Wossner, dunno?

Not mine..!

I try to stop suppliers from getting 'attacked' publicly on the internet - that is the reason for that Protocol. There is no question of that here.

Thanks again,

G
Giulio
Posts: 14
Joined: June 22nd, 2010, 5:42 pm
Location: Turin, ITALY

Re: My Fiat Strada 130 TC - restore and tuning

Post by Giulio »

OK Guy, thank you for pointing that.
They are CPS pistons.

Now it's time for cranckshaft and flywheel.
Here are some pics after polishing, refacing flywheel, and balancing (individually and fully assembled).
No need for grinding crankshaft; luckily it was checked and in good condition, according to Fiat original tolerances (I have read the topic about regrindind 2L crankshaft and nitriding process...)

Next step: assembling pistons and rods !
Bye
Giulio.
Attachments
Immagine 033.jpg
Immagine 033.jpg (118.76 KiB) Viewed 3742 times
Immagine 035.jpg
Immagine 035.jpg (140.43 KiB) Viewed 3742 times
Immagine 045.jpg
Immagine 045.jpg (121.3 KiB) Viewed 3742 times
Immagine 050.jpg
Immagine 050.jpg (175.13 KiB) Viewed 3742 times
Immagine 052.jpg
Immagine 052.jpg (137.96 KiB) Viewed 3742 times
Post Reply

Who is online

Users browsing this forum: No registered users and 45 guests