Self build flow bench

Road-race engines and ancillaries - general discussion
4v6
Posts: 195
Joined: March 20th, 2007, 1:20 pm
Location: Midlands UK (A)
Contact:

Re: Self build flow bench

Post by 4v6 » September 17th, 2011, 1:23 pm

Thank you Guy.

Port angle as measured is as close to 45 degrees as i could measure, from the intake manifold face meaning if my math is up to par 45 degrees from the combustion face also.

The seat profile is as per OEM with the seat taken out to to diameter of the valve.
The head is Volkswagen Golf Mk1, "DX" model code, you've likely done many of them I would think.
I hope these photos will do, I dont appear to have one with the port angle in a profile type of shot unfortunately.

Best wishes, Tony.
P1030420 (1000 x 750).jpg
P1030420 (1000 x 750).jpg (178.01 KiB) Viewed 2588 times
P1030442 (1000 x 750).jpg
P1030442 (1000 x 750).jpg (174.16 KiB) Viewed 2588 times
Tony Warren. GC #96.

Guy Croft
Site Admin
Posts: 5029
Joined: June 18th, 2006, 9:31 am
Location: Lincoln, UK
Contact:

Re: Self build flow bench

Post by Guy Croft » September 17th, 2011, 1:38 pm

Thanks Tony

yes - a fair bit of downdraft - those seat angles should be OK. Thanks for the pics.

G

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests