Measuring for shims Hot or Cold?

Road-race engines and ancillaries - general discussion
Post Reply
Posts: 62
Joined: June 22nd, 2006, 7:11 pm
Location: Teesside UK

Measuring for shims Hot or Cold?

Post by parrish » June 7th, 2011, 5:21 pm

Im sure their is a link here somewhere to a previous discusion on this subject, however i dont know where.
My question's are: 1) When measuring the gap for calculating the required shim, should this be carried out on a hot or cold engine? 2) and what is the exact procedure.
Parrish 366

Guy Croft
Site Admin
Posts: 5024
Joined: June 18th, 2006, 9:31 am
Location: Lincoln, UK

Re: Measuring for shims Hot or Cold?

Post by Guy Croft » June 8th, 2011, 8:33 am



Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest