X1/9 1600 stroker engine

Road-race engines and ancillaries - general discussion
Post Reply
Rehan
Posts: 1
Joined: Thu Mar 03, 2011 8:55 pm

X1/9 1600 stroker engine

Post by Rehan » Sun Mar 06, 2011 8:12 pm

Hi everyone

This is my first post and, at the outset, I would like to inform everyone that I am not technically experienced in the art of engine building. I love X1/9s and am in the process of getting a car restored in USA (road use only) for ultimate delivery to my home in Dubai.

I have read in other forums that it is possible to increase the capacity of the stock engines to 1600cc by changing the crankshaft and pistons. A few questions:

1. Does anyone on this forum have experience with this conversion?

2. Which crankshaft (from the current / recent range of Fiat engines) could be used for this conversion?

3. I understand that the standard 1500 pistons would need to be "shortened" to avoid moving too far up in the compression stroke. Is there a safe way to do this? Alternatively, are there any suitable replacement pistons that can be used (maybe with some boring of the block)?

4. If replacement parts for the bottom end are available, can anyone advise me of the source?

5. How should the head be modified (remember -- road use only)? Advice on valve sizes / camshaft specs would be greatly appreciated.

6. Any other advice on suitable modifications?

FYI -- the car is fuel injected but I plan to change the ECU for a programmable unit. Work will be carried out by a specialist in Ohio. I was seriously considering a Punto engine swap but am put off due to lack of availability of these engines in USA and the potential liability issue of buying such an engine in UK / Europe and shipping it to USA for installation and tuning.

I am sorry for my ignorance but would appreciate some advice.

Regards

Rehan

Guy Croft
Site Admin
Posts: 5032
Joined: Sun Jun 18, 2006 10:31 am
Location: Lincoln, UK
Contact:

Re: X1/9 1600 stroker engine

Post by Guy Croft » Fri Mar 11, 2011 9:54 am

Hi - sorry no-one has picked this up

I am personally dead-against mix and match of rods, cranks, bearings between models which is why I have avoided this thread. Most folk I know (and I've known a lot) have enough problems achieving the kind of results I publicise and reliability too even with the original core components. And that's fair enough, as mostly they are DIY amateurs (in the nicest sense), often new to tuning.

There are those in the world who claim great success from that kind of thing but it is unfortunately possible they are not on this forum.

G

tmvolumex
Posts: 165
Joined: Fri Jul 07, 2006 1:43 am
Location: USA
Contact:

Re: X1/9 1600 stroker engine

Post by tmvolumex » Wed Mar 30, 2011 10:15 pm

PBS Engineering in California, USA made and sold stroker crankshafts that brought the 1500 cc engines up to 1600 cc's.
PBS discontinued making and selling these years ago (more than 10 years ago) and is now focused on making sequential gearboxes for racing.
GC_31

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests