Block core plugs

Crank, rods, sealing, pistons, block, flywheel etc
Locked
Guy Croft
Site Admin
Posts: 5039
Joined: June 18th, 2006, 9:31 am
Location: Bedford, UK
Contact:

Block core plugs

Post by Guy Croft »

What are they for? To stop the block cracking if it freezes in winter? No.
Some functional purpose? Not really.
Core plugs are just a necessary feature of casting, without them you can't make some parts.

They should always be replaced on overhaul, because although they might look fine on the outside, they can be seriously corroded on the inside due to neglect of coolant & additive, in some cases wafer thin or just about to develop 'pin-inappropriate' holes.

Some firms use fabulous bolting systems to hold the core plugs in place, never quite understood the need, the plug should stay in merely as an 'interference fit', unless it is the wrong size for the bore. Must be some kind of high pressure cooling system to push out a core plug...
Attachments
Tools for knocking plugs into place - hammer and drift. If you don't have the exact tool you can make one or use a big socket...
Tools for knocking plugs into place - hammer and drift. If you don't have the exact tool you can make one or use a big socket...
Core plugs and tools.JPG (164.86 KiB) Viewed 22980 times
A little silicon sealant around the bore is a good idea, make sure the bore is thoroughly cleaned with fine abrasive paper.
A little silicon sealant around the bore is a good idea, make sure the bore is thoroughly cleaned with fine abrasive paper.
Core plugs & sealant.JPG (172.07 KiB) Viewed 22980 times
Core plug fitted, make sure it is fully fitted in the parallel section, often there is a chamfer on the outer edge, and not tilted over - it may leak.
Core plug fitted, make sure it is fully fitted in the parallel section, often there is a chamfer on the outer edge, and not tilted over - it may leak.
Core plug fitting.JPG (169.03 KiB) Viewed 22974 times
Locked

Who is online

Users browsing this forum: No registered users and 9 guests