Urgent: Flywheel step needed
Posted: April 11th, 2013, 5:13 pm
Hi everyone,
I am making a clutch conversion on my Dedra 8v turbo. Until yesterday I had a 230mm cerametallic plate and a stock Valeo push type cover. I am switching to a pull type cover from a Thema 16v turbo (also went on AR 155q4, 2.0 v6 turbo and 3.0 v6) and I will be using an organic plate from a 2.4 JTD engine (235mm diameter).
I redrilled the flywheel for the new cover but I am not sure about the flywheel step. Now it doesn't have any, like a local specialist suggested. I am not sure that is correct and I wouldn't like to change the clutch again too soon.
Can anyone specify the FW step used on the above mentioned engines?
or
When I lay the cover over the plate there is a 4.2mm gap. Is this enough?
Thanks!
Uros
I am making a clutch conversion on my Dedra 8v turbo. Until yesterday I had a 230mm cerametallic plate and a stock Valeo push type cover. I am switching to a pull type cover from a Thema 16v turbo (also went on AR 155q4, 2.0 v6 turbo and 3.0 v6) and I will be using an organic plate from a 2.4 JTD engine (235mm diameter).
I redrilled the flywheel for the new cover but I am not sure about the flywheel step. Now it doesn't have any, like a local specialist suggested. I am not sure that is correct and I wouldn't like to change the clutch again too soon.
Can anyone specify the FW step used on the above mentioned engines?
or
When I lay the cover over the plate there is a 4.2mm gap. Is this enough?
Thanks!
Uros